Flluid 1
53
MAINTENANCE
Cranks
Pedals
Check regularly if the pedals (3) are screwed
rmly on the cranks. Note that the pedals
have different threads.
Left pedal with left-hand thread is tightened
counterclockwise. Right pedal with right-
hand thread is screwed clockwise.
A corresponding mark is on the pedals
located near the at area a corresponding
mark: "L" for the left side, "R" for the
right side.
Tighten the pedals with ngers rst, and
then tighten with a 15mm wrench.
Follow:
- Retighten screws on (2) on both sides.
NOTE
If the cranks have already loosened, the
inner square / alignment is mostly off.
The cranks are replaced, the axle must
then be replaced. Disassemble the xed
crank only with a crank puller, never knock
down with force.
When installing, the square bearing surfaces
of the crank and axle must be completely
free of grease.
The cranks (1) can loosen over time while
driving. Check regularly if the cranks are
tight. To inspect move the cranks vigorously
sideways, no play should be felt.
Check the bottom bracket regularly. To
do this, move the cranks back and forth
sideways.
If you nd that the cranks or bottom bracket
are loose, visit a service center.
The cranks should be tightened to max.
40-45 Nm (30-33 ft-lb)
2
1
3
R
To Next Page
Loading...
