Flluid 1
67
SERVICE
Possible Errors Remedy
The system can not be switched on via the
control panel
The battery is not charged
The battery is defective
The fuse in the battery is blown
The battery is not turned on
The battery contacts are dirty
The plug connection to the display has come off - restore contact
The control panel / display is defective
The display is on, but there is still no assist The assist mode is set to "0".
The speed is higher than 20/28 mph Flluid1/1S
The battery is almost empty and the last bar in the display ashes
The battery contacts are dirty
"error 23" or "error 24" is displayed; the plug connection to the engine has come off –
restore contact
The motor does not work despite correct
operation
A brake contact has an error - Check cable contacts or replace the lever unit; if neces-
sary, the display shows "error 25"
The distance of the magnetic disc to the sensor on the belt wheel is> 3mm; this dis-
tance must be corrected
The engine does not deliver the same
performance as immediately after product
purchase
Turn the system off and on again; adjust the power settings, if there is still no improve-
ment, the battery may require maintenance – please email FUELL.
The engine shuts off when driving uphill The max. motor temperature has been exceeded and the motor power is withdrawn
for safety reasons. The load of the engine is too large - the engine switches off for
self-protection
Engine does not work at low temperatures. Under a temperature of -10 ° C, there is no power from the battery, as this could dam-
age it. Warm the battery slowly
Error Checklist
To Next Page
Loading...
