Fuji Electric MICREX-SX series - Analog Input;Output Module Interface

4-26
Section 4 Software Interface
4-3 Analog Input/Output Module
NP1AWH6-MR occupies 8 words of I/O area (input: 4 words, output: 4 words).
4-3-1 Memory allocation in Switch Batch Setting mode
This module to CPU module
CPU module to this module
Offset
address
15(F)
+0
+1
+2
+3
+4
+5
+6
+7
Channel 1 Digital output value / Status
Channel 2 Digital output value / Status
Channel 3 Digital output value / Status
Channel 4 Digital output value / Status
Channel 5 Digital input value
Channel 6 Digital input value
Unused (fixed to 0 (zero))
Unused (fixed to 0 (zero))
0
Status code Error Descrip tion
30002
(7532h)
EEPROM calibration data
error (Module fatal fault)
If the cali bration data of EEPROM i s destroyed or if EEPROM cannot be
written or read, this error is notified. Module internal EEPROM is abnormal.
If thi s error occurred, it is necessary to replace the module.
30003
(7533h)
EEPROM user setting data
error
If the user setting data of EEPROM is destroyed, this error is noti fied.
If thi s error occurred, all parameters need to be reset. If thi s error recurs
even after parameters are reset, the module seems to have failed.
30004
(7534h)
Internal power supply down
If the internal power supply of the module becomes down, this error is
notified.
30006
(7536h)
Conversion error
If conversion became abnormal because the module failed or was used in an
out-of-spec environment, this error is notified.
Ordinarily digital output values (INT type) are stored in the registers explained above. If the module becomes
abnormal, the following status code (INT type) is stored in these registers. When making an application program,
be sure to interlock erroneous and normal (A/D conversion) conditions.