9.5.7.2 Add the Device to the Configuration
Select the device in the Hardware catalog and drag the device into the PROFINET IO system
configuration as shown in Figure 92.
Figure 92: Add Device to Configuration
9.5.7.3 Select the IO Controller
On the device, click “Not assigned” and s elect the appropriate PLC
PROFINET interface as shown in Figure 93. This will assign the
device to the PROFINET IO system as shown in Figure 94.
Figure 94: PROFINET IO System
9.5.7.4 Assign IO Module
Click on the device and then click on the Device view tab. In the Hardware catalog, expand Module
and add a module “IN: XX WORDS, OUT: YY WORDS” into Slot 1. The module will determine the input
and output sizes. In this example, the module “IN: 02 WORDS, OUT: 02 WORDS” is selected. Select a
module with the appropriate input and output sizes for your specific application. Refer to Figure 95.
Figure 95: Add IO Module
Figure 93: Select IO Controller
To Next Page
Loading...