• Right-clicking on it and choosing Copy from the context-sensitive menu.
• Pressing the <CTRL+C> keys on the keyboard.
• Holding the <CTRL> key and dragging the item to the desired location in the Project panel.
• Dragging the item to a new location under a different parent object in the Project panel.
• Selecting Copy Selected Item from the Edit menu.
• Clicking on the Copy button in the toolbar.
To paste an obj ect, first click on an item at the desired location in the Project panel. An object can then
be pasted by:
• Right-clicking on it and choosing Paste from the context-sensitive menu.
• Pressing the <CTRL+V> keys on the keyboard.
• Dropping an item onto the desired location in the Project panel after holding the <CTRL> key and
dragging the item.
• Dropping an item onto a new location under a different parent object in the Project panel after
dragging the item.
• Selecting Paste Item from the Edit menu.
• Clicking on the Paste button in the toolbar.
After pasting an object, the object’s configurable fields can then be modified with valid values (where
applic able).
Note that the studio allows you to copy and paste items between different locations, including different
devices. This is useful for copying partial configurations from one device to another.
Reordering Objects
Objects can be reordered in the Project panel by dragging the item to the desired location. If the item is
dragged outside of the items in the project tree, it will be moved to the end.
5.3 Ethernet Settings
The Ethernet Settings panel contains Ethernet-related items that are not specific to any given protocol.
These settings must be appropriately configured regardless of any Ethernet control protocols that may
be enabled. The Ethernet Settings panel is then available whenever the Ethernet port is selected in
the Project panel.
5.3.1 Authentication
Be sure to make a note of the new settings whenever authentication credentials are changed, as they
must be entered whenever the web page is accessed or an FTP session is initiated.
User Name
The username is case-sensitive and can contain letters (“a...z” and “A...Z”) and numbers (“0...9”).
Password
The password is case-sensitive and can contain letters (“a...z” and “A...Z”) and numbers (“0…9”).
5.3.2 Network Configuration
The card supports a static IP address. The IP Address, Subnet Mask and Default Gateway fields must
be configured. Please consult with your network administrator for the proper settings of these fields.
5.4 Internal Logic Settings
5.4.1 Fail-safe Values
5.4.1.1 Overview
The card can be configured to perform a spec ific set of actions when network communications are lost
(timeout event). This allows each inverter parameter to have its own unique “fail-safe” condition in the
event of network interruption. Support for this feature varies depending on the protocol: refer to the
protoc ol-specific section of this manual for further information.
To Next Page
Loading...