Fuji Electric OPC-PRT - Default Supported Objects

91
9.4.2 Default Supported Objects
This section will describe the default objects. Since the objects are configurable, the system integrator is
responsible for managing, maintaining, and documenting the actual configuration.
Always use the studio to confirm the configuration before commissioning the device
Table 32: Binary Input Object Instance Summary
Instance ID
Object Name Description
Active/
Inactive Text
BI1
FWD_ROT_STATUS
Forward rotation status
forward/off
BI2
REV_ROT_STATUS
Reverse rotation status
reverse/off
BI3
EXT_STATUS
DC injection braking
braking/off
BI4
INVERTER_SHUTDOWN
Inverter shutdown
on/off
BI5
BRAKING
Braking
braking /off
BI6
NUV
DC bus voltage normal
on/off
BI7
TORQUE_LIMITING
Torque limited
on/off
BI8
VOLTAGE_LIMITING
Voltage limited
on/off
BI9
CURRENT_LIMITING
Current limited
on/off
BI10
ACCELERATING
Accelerating
on/off
BI11
DECELERATING
Decelerating
on/off
BI12
ALARM
Alarm
on/off
BI13
COMM_ESTABLISHED
Communications established
on/off
BI14
BUSY_WRITING
Busy writing
on/off
Table 33: Binary Output Object Instance Summary
Instance ID Object Name Description
Active/
Inactive Text
BO1
FWD_ROT_CMD
Forward rotation c ommand
forward/off
BO2
REV_ROT_CMD
Reverse rotation command
reverse/off
BO3
X1
General purpose input
on/off
BO4
X2
General purpose input
on/off
BO5
X3
General purpose input
on/off
BO6
X4
General purpose input
on/off
BO7
X5
General purpose input
on/off
BO8
X6
General purpose input
on/off
BO9
X7
General purpose input
on/off
BO10
X8
General purpose input
on/off
BO11
X9
General purpose input
on/off
BO12
EN_TERMINAL
Enable terminal
on/off
BO13
XF_FW D
General purpose input
on/off
BO14
XR_REV
General purpose input
on/off
BO15
ALARM_RESET
Alarm reset
on/off
Table 34: Analog Input Object Instance Summary
Instance ID Object Name Description Units
AI1
OUTPUT_FREQ
Output frequency
Hz
AI2
OUTPUT_CURRENT
Output current
Amps
AI3
OUTPUT_VOLTAGE
Output voltage
Volts
AI4
INPUT_POWER
Input power
kW
AI5
OUTPUT_POWER
Output power
kW