Set the properties to match the
configuration on the device. The
properties must be appropriate for the
application and the PROFINET network.
Set the Update Rate (ms). For this
example, the Update Rate (ms) is s et to
“8” ms.
Assign a unique Device Name. For this
example, the Device Name is set to
“interfacecard”.
Assign a unique and compatible IP
Address. For this example the IP
Address is set to “192.168.17.102”.
The resulting properties are shown in Figure 111.
9.5.8.5 Save the Configuration
The device configuration is now complete. Save and perform any necessary compilation of the
configuration. Download the application and configuration to the PLC. The PLC application program can
then be started. Pleas e c onsult with the vendor of your PROFINET PLC software for additional
programming and configuration details.
Figure 111: Set Device Properties
To Next Page
Loading...