5 FUJI CONFIGURATION STUDIO
5.1 Overview
The interface card is discovered, configured and updated by the Fuji Configuration Studio PC application
(refer to Figure 8). The studio must be installed prior to connecting an interface card to the computer in
order to ensure that the appropriate USB drivers are installed. The studio typically requires a USB
connection for reading/writing a configuration and updating the firmware. Depending on the currently-
active drivers, remote discovery, network setting, configuration, and firmware updates are also possible
via Ethernet. To obtain the latest release of the Configuration Studio, refer to the product web page
on
the internet or contact technic al support. The remainder of this section will provide only a brief
introduction to the configuration concepts. For protocol specific configuration, refer to the relevant
protocol section.
Figure 8: Fuji Configuration Studio
Creating a Device Configuration
A device can be added to the Project panel for configuration by first selecting the Device
Configurations list heading and then:
• Double-clicking on the device in the Available Devices panel.
• Right-clicking on the device in the Available Devices panel and choosing Add from the context-
sensitive menu.
• Hitting the <ENTER> key on the keyboard when the device is selected in the Available Devices
panel.
• Dragging the device from the Available Devices panel into the Project panel.
• Selecting it and selecting Add Selected Device from the Edit menu.
• Selecting it and clicking the Add button in the toolbar.
The device will then be added to the list of Device Configurations.
Going Online with a Device
All connected devices are automatically added to the Discovered Devices panel. This panel is shown
by selecting the Online Devices list heading in the Project panel. To go online with a device:
• Double-click on it in the Discovered Devices panel.
To Next Page
Loading...