5 Tools
144
Tools
5
• Searching for images and print job logs allows the system administrator to grasp the
identification information of the user who instructed the job. Note that Fuji Xerox is not
responsible for a privacy issue of the user caused by using the Image Log Control feature.
• In the event of forced power failure such as a blackout or a hard disk failure, it is not
guaranteed the image logs are securely created and/or transferred.
• Only the jobs performed after the start of the Image Log Control feature will be covered by
the Image Log Control feature.
• Because the images to be controlled are created based on the input images, the images will
not always be the same as the output images. The following information is added or edited
during output; thus, the images will not be reflected.
• For PDF files created as images, the [PDF Security] feature and the [PDF Signature] feature
cannot be used.
• Images with higher resolution than the input image cannot be created regardless of the
setting of [Resolution] under [Image Log Generation]. If the resolution of the input image is
lower than the setting of [Resolution] under [Image Log Generation], the machine creates an
image with the same resolution of the input image.
• For jobs of fax transmissions, the machine always operates as [Low] is set to [Assurance
Level] regardless of the settings of the machine.
• Up to 8191 pages of images can be created. If more than 8191 pages of images are input
into the machine, even if [All Pages] is selected for [Page Range] under [Image Log
Generation], not more than 8191 pages can be created.
• If the machine runs out of hard disk space for storing images, the machine operates in
accordance with the setting of [Image Log Generation] > [Assurance Level] as follows.
- [High]: A job is cancelled.
- [Low]: A job is executed. However, the warning will be displayed at the end of the job and
notifies the user that the image creation failed.
• Up to 200 image logs can be stored in the machine.
• The text size of image logs differs depending on the setting of [Resolution] under [Image Log
Generation]. Refer to the following table when you set the resolution.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• If you set [Service Rep. Restricted Operation] to [On], our service representatives cannot
change the [Image Log Control] settings. For more information on Service Rep. Restricted
Operation, refer to "Service Rep. Restricted Operation" (P.154).
Image Log Control
Set whether or not to use the Image Log Control feature.
z
Layout change during
output
z
Secure Watermark
z
Image composing such as
repeating images (Copy)
z
Separator
z
Banner
z
Booklet Creation (Copy)
z
Annotation
z
Cover Page (Fax)
z
Form Overlay (Print)
z
Watermark
Resolution
Character
Size
Remarks
200 dpi 6 pt Adequate level for normal document
100 dpi 14 pt Large size characters are legible.
72 dpi (default) 18 pt Title size characters are legible.
50 dpi 24 pt Characters are illegible. Suitable for Preview
25 dpi 32 pt Characters are illegible. Suitable for
Thumbnail view
To Next Page
Loading...
Need help?
General
