Fuji Xerox DocuCentre-IV 4070 User Manual

3 Maintenance
68
Maintenance
3
Replacing Staple Cartridge (for Finisher-C1 or Finisher-C1 with Booklet
Maker)
When the Finisher-C1 (optional) or Finisher-C1 with Booklet Maker (optional) is
installed and the staple cartridge needs to be replaced, a message appears on the
touch screen. When this message appears, load a new staple case into the staple
cartridge.
This section explains how to replace the staple cartridge in the Finisher-C1 with Booklet
Maker, as an example. You can apply the same procedures to the Finisher-C1.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front door.
2 Grasp the handle [R1] of the staple cartridge
holder, and pull out the holder to the right,
towards you.
3 Pull the staple cartridge out of the finisher.
Note • The staple cartridge is firmly inserted. A
slight force is required to pull the cartridge
out of the finisher.
4 Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
[R1]
1
1
2

Fuji Xerox DocuCentre-IV 4070 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 4070
Category	Copier
Language	English