16 Appendix
598
Appendix
16
PCL Emulation Settings
The following table shows the emulation parameters and their values for PCL
emulation.
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter
I
tem
No.
Value
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
[6] : Tray 6 (HCF)
Important • When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper Size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the same orientation
in multiple trays is loaded, paper will be fed in the order of Tray 1 J Tray 2
J Tray 3J Tray 4 J Tray 6. If paper of the same size is loaded in multiple
trays but in different orientations, feeding of the paper loaded in the
landscape orientation is prioritized.
Auto size 202 Sets the default paper size. Only available when [Paper Tray] is set to [Auto].
Only cut sheet can be set.
[3] : A3
[4] (Default) : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 × 14”
[22] : 8.5 × 13”
[23] (Default) : 8.5 × 11”
[24] : 11 × 17”
[25] : Custom Size
[30] : 8K
Important • When Trays 1 to 4, Tray 6 is selected, [Paper Size] cannot be set. The
paper size loaded in the specified tray is displayed.
Note • When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper Size] cannot be set.
• Depending on the combination of [Original Size] and [Paper Size], [?] may
be displayed for the magnification. In this case, the document is printed at a
scale of 100%.
To Next Page
Loading...
Need help?
General
