Replacing Consumables
69
Maintenance
3
5 Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6 Push the staple cartridge into the finisher
until it clicks into place.
7 Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
remain paused.
Replacing Booklet Staple Cartridge
(for Booklet Maker Unit for Finisher-B1)
When the Booklet Maker Unit for Finisher-B1 (optional) is installed and the staple
cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher side cover.
2 Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
1
2
To Next Page
Loading...