EasyManuals Logo

Fuji Xerox DocuCentre-IV 4070 User Manual

Fuji Xerox DocuCentre-IV 4070
675 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #333 background imageLoading...
Page #333 background image
Installation Procedures
333
Using IP Fax (SIP)
10
Installation Procedures
This section describes the configuration procedures to use the IP Fax (SIP) feature on
the machine.
The following shows the reference section for each procedure.
Step 1 Enabling Port and Setting up TCP/IP............................................................................ 333
Step 2 Configuring the SIP User Name ................................................................................... 334
Step 3 Configuring Fax Environment ...................................................................................... 335
Step 4 Configuring the SIP Server ........................................................................................... 336
Step 5 Registering the VoIP Gateway...................................................................................... 337
Step 1 Enabling Port and Setting up TCP/IP
To use the IP Fax (SIP) feature on the machine, enable the port and set the IP
addresses. The following shows the configuration procedures on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.273).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the SIP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SIP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. If an IP address cannot be obtained automatically, or if manual
configuration is preferred, confirm the settings of an IP address, a subnet mask, and a
gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.169).
4 Select [Close] repeatedly until the [Tools] screen is displayed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-IV 4070 and is the answer not in the manual?

Fuji Xerox DocuCentre-IV 4070 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-IV 4070
CategoryCopier
LanguageEnglish

Related product manuals