9 Scanner Environment Settings
328
Scanner Environment Settings
9
Configuration of Store to WSD
This section describes how to configure the machine to use the Store to WSD service.
The following shows the reference section for each procedure.
Step 1 Preparations....................................................................................................................328
Step 2 Enabling Port .................................................................................................................328
Step 3 Confirmation on the Computer ......................................................................................329
Step 1 Preparations
The following environment is required to use the Store to WSD feature on the machine.
z
The following operation system must be installed on a destination computer.
- Microsoft Windows 7
- Microsoft Windows Vista Service Pack 2
Step 2 Enabling Port
To use the Store to WSD service, enable the WSD scan port. The following describes
the configuration procedures on the machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.273).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter]. When a passcode is required, select
[Next] and enter the system administrator's passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [WSD], and then select [Change Settings].
4) Select [WSD Scan - Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
4 Print a configuration report to confirm that the WSD port is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.87).
To Next Page
Loading...