Notes and Restrictions
639
Appendix
16
îš„Notes on E-mail Transmission when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, split the data so
as to enable e-mail reception with e-mail software corresponding to the Message/
Partial content type.
îš„Job Counter Report
If you specify multiple different [Pages per Side] settings using the Build Job feature,
the numbers of pages displayed for [2 Pages] and [Greater than 2 Pages Up] displayed
on the Job Counter Report are calculated according to the latest N-up setting you
specify.
Example 1:
When you select [2 Pages] for Document 1 (4 pages) and [Off] for Document 2 (2
pages), both Documents 1 and 2 are set to [Off] and the number of printed pages is
calculated as follows:
z
Total pages: 4
z
2 up: 0
Example 2:
When you select [Off] for Document 1 (4 pages) and [2 Pages] for Document 2 (2
pages), both Documents 1 and 2 are set to [2 Pages] and the number of printed pages
is calculated as follows:
z
Total pages: 5
z
2 up: 5
On ApeosWare Log Management or ApeosWare Accounting Service, the numbers of
pages for 2in1, 4in1, and 8in1 are also calculated in the same way as described above.
The meter on the [Billing Information] screen calculates the number of printed pages
correctly regardless of the [Pages per Side] setting.
îš„Folder Passcode
z
You do not need to specify the passcode of a recipient when sending an IP Fax (SIP)
to a remote folder. Thus, the passcode enclosed in "\" or "/" is not replaced by "*" as
with that of regular faxes. If you select an IP Fax (SIP) by mistake and specify the
passcode of a recipient when you send a fax or an Internet fax, the passcode is
displayed on the touch panel screen, the Job Status screen, and a report. Be sure to
check the type of fax before sending a fax to a remote folder.
z
Communications and Information network Association of Japan (CIAJ) confirms the
use of image-/tiff-fx.
Notes and Restrictions for IP Fax (SIP)
This section describes notes and restrictions to observe when using IP Fax (SIP).
IP Fax (SIP) Feature
z
In IP Fax (SIP) transmissions, protocols used for call connection are SIP and for data
communication is T.38. Other IP Fax transmissions protocols, such as H.323
standard and deemed voice communication method, are not supported.
z
IP Fax (SIP) cannot be performed on SSL/TLS communication.
To Next Page
Loading...
Need help?
General
