Fuji Xerox DocuCentre-IV 4070 User Manual

1 Before Using the Machine
22
Before Using the Machine
1
5 Connect a parallel cable to the parallel
interface connector and fasten it with the
clips on either side of the connector.
6 Connect the other end of the parallel cable to the computer.
7 Press the main power switch to the [ | ] position to switch on the main power.
8 Close the front cover.
9 Press the power switch to the [ | ] position to switch on the power.
10 Restart the computer.
For more information on setting items, refer to "Printer Environment Settings" (P.277).
Using the Ethernet Interface
The Ethernet interface of the machine supports the following three types.
z
1000BASE-T (optional)
z
100BASE-TX
z
10BASE-T
This section describes the installation procedures for the Ethernet interface.
1 Press the power switch to the [ ] position to switch off the power.
2 Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
3 Open the front cover.
4 Press the main power switch to the [ ] position to switch off the main power.
5 Connect a network cable to the Ethernet interface connector.
z
When the Gigabit Ethernet Board
(optional) is installed.

Fuji Xerox DocuCentre-IV 4070 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 4070
Category	Copier
Language	English