4 Machine Status
98
Machine Status
4
Programming
You can check or change the value set for the print mode item number.
For the item numbers that can be configured in each mode menu, refer to "ESC/P-K Emulation Settings"
(P.578), "PDF Direct Print Settings" (P.591), "PCL Emulation Settings" (P.598), and "HP-GL/2
Emulation Settings" (P.605).
1 Select [Programming].
2 Enter the item number of the feature to set in
[Item Number] with the numeric keypad.
3 Select [Confirm]. The current setting value appears.
4 Select [Change Value].
5 Enter [New Value] with the numeric keypad.
6 Select [Save].
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1 Select [Store/Delete Programming].
2 Select [Store Current Selections] or [Delete].
îš„Store Current Selections
Stores the current selections. If you select a number already used, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
îš„Delete
Deletes a number selected. Select [Delete], and then select a number to delete.
Important • Deleted numbers cannot be restored.
3 Select the memory number to store or to delete.
To Next Page
Loading...
Need help?
General
