Fuji Xerox DocuCentre-V 3060

Tools
192
Tools
5
 Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
 Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important
z
Do not use the numbers assigned to the other ports.
 Secondary Server Name/Address
Enter the secondary server name or IP address.
Note
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important
z
Do not use the numbers assigned to the other ports.
 Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server® 2003, Windows
Server 2008, or Windows Server 2012 as server, specify the domain name of Active
Directory in [Domain Name]. Up to 64 characters are allowed.
Important
z
Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
 Server Certificate Verification
Select whether or not to verify a server certificate.