Fuji Xerox DocuCentre-V 3060

Using IP Fax (SIP)
370
Using IP Fax (SIP)
10
4 Select [Close].
Note
z
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
5 Print a configuration report to confirm that the port is enabled and TCP/IP setting is set up
correctly.
Note
z
For information on how to print a settings list, refer to "Print Reports" (P.95).
Step 3 Configuring Fax Environment
This section describes the configuration procedures of the Fax feature related to IP fax
(SIP) on the machine.
Reference
z
You can configure the settings using CentreWare Internet Services. For information on how to use CentreWare Internet Services,
refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.313).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2 Set items displayed on the [Fax/Internet Fax] screen.
1) Select [Fax Service Settings].
2) Select [Screen Defaults].
3) Configure the required settings, and then select [Save].
Reference
z
For information on the screen default, refer to "Screen Defaults" (P.222).
3 Set the default settings of the Fax feature.
1) Select [Fax Defaults].
2) Configure the required settings, and then select [Save].
Reference
z
For information on the fax default, refer to "Fax Defaults" (P.223).
4 Configure the settings related to fax control.
1) Select [Fax Control].