EasyManua.ls Logo

Fuji Xerox DocuCentre-V 3060

Fuji Xerox DocuCentre-V 3060
751 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparations
377
Using the Internet Fax Service
11
Preparations
This section describes the prerequisites to use the Internet Fax on the machine.
System Requirements for the Machine
z
The machine is connected to a network via TCP/IP.
z
The environment is prepared for e-mail transmissions.
E-Mail Environment
To use the Internet Fax feature, configure the following settings for your e-mail
environment.
O: Required U: Set as required -: Not supported
* : When you use the Internet Fax Direct feature, set [Tools] > [System Settings] > [Fax Service Settings] > [Internet Fax Control] >
[Internet Fax Path] to [Direct (P2P)].
Reference
z
To transmit e-mails encrypted by S/MIME or with digital signatures attached, a certificate must be ready in advance. For more
information on a certificate, refer to "Configuration of E-mail Encryption/Digital Signature" (P.401).
Item Description Internet Fax Internet Fax
Direct
*
via
SMTP
via
POP3
via SMTP
TCP/IP address TCP/IP address of the machine.
TCP/IP protocol is used for e-mail transmissions.
OO O
Subnet mask The subnet mask is required when a network is
divided into subnetworks.
UU U
Gateway address The gateway address is required when multiple
networks are used via gateways.
UU U
The machine's e-
mail address
Set the machine's e-mail address.
OO O
DNS server address The address is required when the address of POP3 or
SMTP server is set not using an IP address but a
domain name. The address can be obtained by
DHCP.
UU U
SMTP server address SMTP server is used for sending e-mails from the
machine. The SMTP server can also be used for
receiving e-mails.
OO -
SMTP AUTH
loginname,
password
When a certification-required SMTP server is used,
configure a user name for authentication. Set the
password as necessary.
UU -
POP3 server Set the POP3 server address. - O -
POP user name Configure the user name for POP receiving. Set the
password as necessary.
-O -
S/MIME settings
S/MIME settings
*2
Configure S/MIME.
UU U

Table of Contents

Related product manuals