Appendix
724
Appendix
16
Using the Telephone
This section describes how to use an external telephone connected to the machine with the
Fax feature.
Placing a Call
The following describes how to place a call using the external telephone.
To place a call, the following two methods can be used:
z
Dialing with the receiver lifted (off-hook dialing)
z
Dialing with the receiver resting in the cradle (on-hook dialing)
Off-hook Dialing
The following describes how to place a call with off-hook dialing.
1
Pick up the receiver of the external telephone.
z
While the machine is in the Power Saver mode, you cannot place a call using the external telephone. To place
a call, press the <Power Saver> button to exit the Power Saver mode.
2
Specify the call destination.
z
The call destination can be specified using the numeric keypad, address numbers, or one-
touch buttons. The Address Book cannot be used.
z
The call destination can be specified also with the keyboard displayed on the screen.
z
To disconnect the call, select [Close].
z
If your telephone line is set to touch-tone, [Tone (:)] does not appear.
z
If you want to send tones (or to use the touch-tone services) while using a pulse line, select [Tone (:)].
z
Some touch-tone services may not be available even if you set your telephone to send tones.
To Next Page
Loading...
