Problem Solving
594
Problem Solving
15
127-310
127-311
127-312
127-313
127-314
127-315
127-320
127-337
127-342
127-353
127-354
127-396
127-398
127-399
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If same
message is displayed again, contact our Customer Support
Center.
127-700
[Cause] The SIP registrar server cannot be used.
[Remedy] Check if the SIP registrar server is available. Also, confirm that
[SIP Registrar Server Setup] is set correctly under [Tools] >
[System Settings] > [Connectivity & Network Setup] > [SIP
Settings] > [SIP Registrar Server Setup].
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the error still
is not resolved, contact our Customer Support Center.
133-226
[Cause] A country code not supported by the machine was specified.
[Remedy] Contact our Customer Support Center.
133-280
133-281
133-282
133-283
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the error still
is not resolved, contact our Customer Support Center.
133-700
[Cause] The staple/hole punch setting was cancelled.
[Remedy] Check whether the staple/hole punch position is correct, and
then execute the operation again.
Error Code
Cause and Remedy
To Next Page
Loading...
Need help?
General
