Notes and Restrictions
689
Appendix
16
îš„ Printed Time in Force Annotation
The time you specified to print a job, the time at which the print job is started inside the
machine, and the time at which the job is actually printed may not be coincident with one
another depending on the machine status and settings or the content of the print job. The
time printed in Force Annotation is the time at which the print job is started inside the
machine.
îš„ Stored Programming
z
The following features and operations cannot be registered on a stored program.
- Registration and call of a stored program
- EP Diagnostic Request
- System Settings
- The [Store to USB] button on the Services Home screen
- The [Network Scanning], [Job Flow Sheets], and [Web Applications] buttons on the
Services Home screen (ApeosPort Series Models only)
- The [Network Scanning], [Job Flow Sheets], and [Web Applications] buttons on the
Services Home screen
- The [Job Flow Sheets], and [Web Applications] buttons on the Services Home screen
(ApeosPort series models only)
- The [Job Flow Sheets], on the Services Home screen
- A custom button to which the Job Flow service is assigned
- Address Book for the Fax/Internet Fax, E-mail, and Scan to PC services
- Buttons that cannot be selected
- The [Language] button on the Services Home screen
- The [Screen Brightness] button on the Services Home screen
- The [Browse] button of the Scan to PC service
- Address editing operation of the E-mail service ([Remove], [Edit], and [Close Menu] on
the pop-up menu)
-
The <Power Save
r> button
z
After registering a program, you may not be able to retrieve the stored program correctly
if you execute the following operations:
- If a Watermark is registered on the program, and you change the default value of the
Watermark after registering the program
- If a passcode of a folder that is subject to operation by a stored program is changed
after the program is registered
- If the settings of the control panel are changed
- If the features registered on the custom buttons are changed
- If the setting is changed with [Tools] > [System Settings] > [Copy Service Settings] >
[Preset Buttons]
- If the program is selected from a list of a job flow or the Address Book
- If a button no longer functions as a result of a change of optional components such as
Finisher
- If the measurement unit such as mm or inch is changed
- If a file is selected from a file list with Job Status
- The use of a scrolling bar when you select an item
îš„ Opening and Closing of the Document Cover during the Power Saver Mode
If you open the document cover during the Power Saver mode, and then start scanning a
document immediately after the machine exits the mode, the detection error of a
document size may occur. In this case, enter the document size manually. It takes a few
To Next Page
Loading...
Need help?
General
