Simple Copy
111
Copy
3
1 Staple
This feature allows you to select whether to staple copied outputs at the top left corner.
The finisher cuts the staple nails depending on the number of sheets. The stapled nails may
be bent depending on the type of paper used.
For the paper type and the number of sheets that can be stapled, refer to "16 Appendix" > "The Paper Type and the Number
of Sheets That Can Be Stapled" in the Administrator Guide.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
1 Select [1 Staple].
To Next Page
Loading...
