Store to WSD
357
Scan
5
1 Select [Computer].
2 Load the document on the document glass or
in the document feeder, and select [Operate
From Computer].
The standby screen is displayed on the touch
screen.
Note • Select [Delete] to exit standby mode. After
exiting standby mode, [Store to WSD -
Remove Your Originals] screen is displayed on
the touch screen.
3 Operate scan from a network computer. To operate scan from a network computer, use
application which supports image loading feature such as [Windows Fax and Scan]. The
following describes the method using [Windows Fax and Scan] with Windows 7.
Note • This method is not available for computers with Windows Vista Home Basic or Windows Vista Home
Premium. To operate scan from such a computer, use another method, for example, selecting [From
Scanner or Camera] in the Paint application.
1) Click the [Start] button, click [All Programs], and then click [Windows Fax and Scan].
2) Click [Scan] at the bottom of the left pane, and then click [New Scan] on the toolbar.
3) In the [New Scan] dialog box, click [Change...], and then select the machine.
4) Check that the machine model name is displayed to the right of [Scanner:].
Note • If the machine model name is not displayed, click [Change] and select the machine.
5) Click the [Profile] list, and then select [Document].
6) Specify the settings as necessary, and then click [Scan].
4 After being scanned, the scanned data is forwarded to the specified computer.
[Store to WSD - Remove Your Originals] screen
appears on the touch screen after a scan job has
been completed.
Note • If the standby screen is not displayed, a scan
job will not be started even when the network
computer recognizes the machine.
• Select [Delete] button to abort an operation.
After an operation is aborted, [Store to WSD -
Remove Your Originals] screen is displayed on
the touch screen.
• The machine will not enter the Power Saver mode while the standby screen is displayed. For
information on Power Saver mode, refer to "Power Saver Mode" (P.82).
• When you select [Flatbed] for [Source], [Paper size] is grayed out and automatically set to the
maximum original size of the machine. To specify [Paper size], select [Feeder (Scan one side)] or
[Feeder (Scan both sides)] for [Source].
5 Remove the originals from the document glass and then click [OK].
To Next Page
Loading...
