Printing Basics 121
5 Slide both width guides until they rest lightly against the edge of the print media stack.
NOTE:
• Do not force the print media into the bypass tray.
6 On the operator panel, select the appropriate paper size, and then press the button.
NOTE:
• If you use the driver setting, select Driver Size.
7 Select the appropriate paper type, and then press the button.
Loading Envelope in the Bypass Tray
Use the following guidelines when loading envelopes in the bypass tray:
IMPORTANT:
• Never use envelopes with windows, coated linings, or self-stick adhesives. These lead to paper jams and can cause damage
to the printer.
NOTE:
• The maximum height (quantity) of envelopes that can be loaded in the bypass tray is approximately 15 mm (0.59 inches) (15
envelopes).
• If you do not load envelopes in the bypass tray right after they have been removed from the packaging, they may bulge. To
avoid jams, flatten them as shown below before loading the envelopes in the bypass tray.
• Com 10, Monarch, or DL
Load the envelopes short edge feed with the flaps closed and the print side up. Ensure that the flaps come at the left
when you face towards the printer.
To Next Page
Loading...
Need help?
General
