176 Using the Operator Panel Menus
• Auto Reset
Purpose:
To automatically reset the settings to the default settings and return to the standby mode after you do not specify any
settings for the specified time.
Values:
• Fault Time-out
Purpose:
To specify the amount of time the printer waits before canceling a job that stops abnormally. The print job is
cancelled if the time-out time is exceeded.
Values:
• Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is cancelled if the
time-out time is exceeded.
Values:
• Clock Settings
Purpose:
To specify the date and time formats.
Values:
*1The default for Date Format varies depending on region-specific factory default.
45sec
*
1min
2min
3min
4min
Off Disables the fault time-out.
On
*
60sec
*
Sets the amount of time the printer waits before canceling a job that stops abnormally.
3–300 sec
Off Disables the job time-out.
On
*
30sec
*
Sets the time the printer waits for data to arrive from the computer.
5–300 sec
Set Date & Time Time Zone Sets the time zone.
Set Date Sets the date depending on the Date Format settings.
Set Time Sets the time.
Date Format yy/mm/dd Sets the date format.
mm/dd/yy
dd/mm/yy
*
Time Format 12H Sets the time in 12-hour format.
24H
*
Sets the time in 24-hour format.
To Next Page
Loading...
