To Next Page

To Previous Page

196 Troubleshooting

Clearing Jams

This section includes:

• "Avoiding Jams" on page 196

• "Identifying the Location of Paper Jams" on page 197

• "Clearing Paper Jams From the Bypass Tray" on page 198

• "Clearing Paper Jams From the Standard 550 Sheet Tray" on page 200

• "Clearing Paper Jams From the Fusing Unit" on page 202

• "Clearing Paper Jams From the Optional 550 Sheet Feeder" on page 205

• "Jam Problems" on page 207

Careful selection of appropriate print media and proper loading allow you to avoid most jams.

See also:

• "About Print Media" on page 110

• "Supported Print Media" on page 112

NOTE:

• Before buying large quantities of any print media, it is recommended that you try a sample first.

 Avoiding Jams

• Use only recommended print media.

• See "Loading Print Media in the Standard 550 Sheet Tray and the Optional 550 Sheet Feeder" on page 117

and "Loading Print Media in the Bypass Tray" on page 120 to load print media properly.

• Do not overload the print media sources. Ensure that the print media stack height does not exceed the

maximum height indicated by the load-line in the tray.

• Do not load wrinkled, creased, damp, or curled print media.

• Flex, fan, and straighten print media before you load it. If a jam occurs with print media, try feeding one sheet at

a time through the bypass tray.

• Do not use print media that you have cut or trimmed.

• Do not mix print media sizes, weights, or types in the same print media source.

• Ensure that the recommended print side is face up when you load the print media.

• Keep print media stored in an acceptable environment.

• Do not remove the feeding tray during a print job.

• Push the tray in firmly after loading.

• Ensure that all cables that connect to the printer are correctly attached.

• Overtightening the guides may cause jams.

• Wipe the feed roller in the tray or bypass tray with a cloth moistened with water if jams caused by misfeeding

paper occur frequently.

Fuji Xerox DocuPrint CP405 d User Manual

Questions and Answers: