214 Troubleshooting
Print Quality Problems
This section includes:
• "The Output Is Too Light" on page 215
• "Toner Smears or Print Comes Off" on page 216
• "Random Spots/Blurred Images" on page 217
• "The Entire Output Is Blank" on page 218
• "Streaks Appear on the Output" on page 219
• "Part or the Entire Output Is Black" on page 219
• "Pitched Color Dots" on page 220
• "Vertical Blanks" on page 221
• "Mottle" on page 221
• "Ghosting" on page 222
• "Light-Induced Fatigue" on page 222
• "Fog" on page 223
• "Bead-Carry-Out (BCO)" on page 223
• "Jagged Characters" on page 224
• "Banding" on page 225
• "Auger Mark" on page 225
• "Wrinkled/Stained Paper" on page 226
• "Damage on the Leading Edge of Paper" on page 227
• "The Top and Side Margins Are Incorrect" on page 227
• "Color Registration Is out of Alignment" on page 228
• "Protrudent/Bumpy Paper" on page 228
• "Images Are Skewed" on page 229
NOTE:
• In this section, some procedures use the operator panel, CentreWare Internet Services or PCL 6 driver.
See also:
• "Understanding the Printer Menus" on page 160
• "CentreWare Internet Services" on page 61
To Next Page
Loading...
