Regulation 23
Regulation
Radio Frequency Emissions (Class B)
Product Safety Certification (UL, CB)
This product is certified by the following agency using the safety standards listed.
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to the
International Standard for Electromagnetic Interference (CISPR Publ. 22) and Radiocommunications Act 1992
in Australia/New Zealand. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this product does cause harmful interference to radio or television reception, which can be determined by
turning this product off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between this product and the receiver.
– Connect this product into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications to this product not specifically approved by Fuji Xerox may void the user’s
authority to operate this product.
Standard
IEC60950-1:ed. 1
To Next Page
Loading...
Need help?
General
