97
FMPC
8.2.9 Paper Condition Setup (421)
See “8.1.3 Paper Condition Setup”.
8.2.10 Processor Solution Temperature
Check (422)
See “8.1.4 Processing Solution Temperature
Check”.
8.2.11 Control Strip Processing (423)
See “8.1.5 Control Strip Processing”.
8.2.12 Print Size Setup (424)
[Selection]
“4 Setup and Maintenance” - “2 Print Condition
Setup and Check” - “4 Print Size Setup”
[Procedure]
Set the print size to be used.
• Normally, the size is registered as shown in the
table below.
■ Print size to be registered in FMPC
No. Name
Width
[0.1mm]
Length
[0.1mm]
Display Border
1 89C 890 1270 ON BL
2 89P 890 2540 ON BL
3 89H 890 1580 ON BL
4 102C 1020 1520 ON BL
5 102P 1020 2540 ON BL
6 102H 1020 1780 ON BL
73R 1270 890 ON BL
8 3RBD 1270 890 OFF BD
95R 1270 1780 OFF BL
10 5RBD 1270 1780 OFF BD
11 4R 1520 1020 ON BL
12 4RBD 1520 1020 OFF BD
13 6R 1520 2030 OFF BL
14 6RW 1520 2160 OFF BL
15 8R 2030 2540 ON BL
16 8RW 2030 3050 OFF BL
17 A5 2100 1480 OFF BL
18 A4 2100 2970 OFF BL
19 8R1 2540 2030 OFF BL
20 10R 2540 3050 OFF BL
21 10RW 2540 3810 OFF BL
22 3DSC 890 1190 OFF BL
23 3DSCf 890 1270 OFF BD
24 4DSC 1020 1360 OFF BL
25 4DSCf 1020 1520 OFF BD
26 5DSC 1270 1690 OFF BL
27 5DSCf 1270 1780 OFF BD
28 89Ix 890 1200 OFF BL
29 CDIDX 1020 1200 OFF BL
30 127Ix 1270 1200 OFF BL
31 3.5x7 890 1780 OFF BL
32 4x5 1020 1270 OFF BL
33 4x8.5 1020 2160 OFF BL
34 4x8 1020 2030 OFF BL
distributed by www.minilablaser.com
To Next Page
Loading...