Fujitsu ASYA18L - 11 Error Codes

En-18
11. ERROR CODES
]1
If you use a wired type remote control, error codes will appear
on the remote control display. If you use a wireless remote
control, the lamp on the photodetector unit will output error
codes by way of blinking patterns. See the lamp blinking
patterns and error codes in the table below.
Abnormal display
Wired
Remote
Controller
Error CODE
Abnormal
contents
OPERATIOR
indicator
lamp
(green)
TIMER
indicator
lamp
(orange)
FILTER
indicator
lamp
(red)
(1) (2)
Remote control
abnormal
communication
(1) (4)
Anomalous
network
communications
(1) (6)
Abnormal
parallel
communication
(3) (1)
Abnormal
power
frequency
(3) (2)
Abnormal
model
information /
abnormal
EEPROM
accession
(4) (1)
Abnormal room
temperature
thermistor
(4) (2)
Abnormal
indoor heat
exchanger
temperature
thermistor
(5) (1)
Abnormal
indoor fan
motor
(5) (3)
Abnormal
drainage
(9) (15)
Abnormal
outdoor unit
Displaymode
:0.5sON/0.5sOFF
:0.1sON/0.1sOFF
 ():Numberofashing
WiredRemoteControllerDisplay
Error code
9371057033-02_IM_en.indd 18 2/20/2009 3:13:45 PM