Important not es
Important notes
ImportantnotesNotes
In this chapt er you will find information regarding s afety which it is essential to
take note of when working with your device.
Safety instructions
This device complies with the re
levant safe ty regulations for data processing equipment,
including electronic office ma
chines for use in an office environment. If you have any
questions, contact y our sales
outlet or our Help Desk.
• The display surface of the de vi
ce is sensitive to pressure and scratches. You should therefore
be careful with the display sur
face in order to avoid lasting damage (scratches).
• If the device is brought into the i nstallation site from a cold environment, condensation
can form. Before operating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing and operatin
g the device , please observe the notes on environmental
conditions in Chapter "
Tech
nical spe cificat ion", Page 26 as well as the instructions in
Chapter "
Setting up an ergon
omic video workstation", Page 8 .
• To ensure sufficient ventilation, the air inlet and outlet openings of the device mu st be kept clear.
• The device automat ically se t
s itself to the correct voltage within the rang e from 100 V to 240 V.
Make sure that the local mains
voltage is neither higher nor lower than this range.
• Ensure that the power socket on the device and the mains outlet are freely acce ssible.
• The ON/OFF switch does not di
sconnect the monitor from the mains voltage. To disconnect
fully from the mains s upply,
disconnect the powe r plug f rom the socket.
• The device is equipped with a power cable that complies with safety sta ndards.
• Use the supplied pow er cable o
nly.
• Lay the cab les in s uch a way that they do not create a hazard (danger of tripping)
and cannot be damaged. When connecting the device, observe the relevant
notes in chap ter "
Connecting the device", Page 12.
• No data transfer cables shou
ld be connected or disconnected during a thunderstorm.
• Make sure that no objects (e.g. jewe llery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
• The device is not waterproof!
Never immerse the device in wate r and protect
it from spray water (rain, se
a water).
• In emergencies (e.g. damaged casing, elements o r cables, penetration of
liquids or foreign m atte r), switch off the device, disconnect the power p lug and
contact your sales outlet or our Help Desk.
• Repairs to th e device must o
nly be performed by qua lifie d technicians. Unauthorised opening
and incorrect repair may gr
eatly endanger the user (electric shock, fire risk ).
• Only use the screen resolution settings and refresh rates specified in Chapter
"
Technical s pecification", Page 26. O therwise you may damage the device . If you
are in an y doubt, contact y our sales outlet or our Help Desk.
• Use a screen saver with movi
ng images an d activate the power management for
your monitor to prevent sti
ll images from "burning in".
• If you operate the device with t he swivel arm or wall bracket, it must not be turned by 180°.
A26361-K1317-Z220-1-761 9, edition 2 3
To Next Page
Loading...
Need help?
General