Importan t n otes
• The device must only be operated in landscape mode (0°) and portrait mode (90°). The
control buttons are located in the middle of the bottom of the monitor in landscape mode
(0°) and at the left-hand side of th e monitor in portrait mode (90°).
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surface. I n view
of the m a ny different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
• To ensure sufficient ventilation, the air supply and air ou tlet openings of
the monitor must never be blocked.
Power cable
Use the supplied p ower cable only.
Use the following guidelines if it is necessary to replace the original cable set.
• The female/male receptacles of the c ord set must meet IEC60320/CE E-22 requirements.
• The cable has to be HAR-certified or VDE-certified . The mark HAR or
VDE will appear on the outer sheath.
• For devices w hich are mounted on a desk or table, type SVT or SJT cab le sets may be
used. For devices which sit on the floor, only SJT type cable sets may be used.
• The cable set must be selected according to the rated current for your device.
• If necessary, replace the original power cable with a regu lar grounded 3-core ma ins lead.
Transporting the d evice
Device,Trans porta tionRetransportation
Tr ansport all parts separately in their original packaging or in a packag ing which
protects them f rom knocks an d jolts, to t he new site.
Do not unpack them until all transportation manoeuvres are comp leted.
If the device is brought from a cold environment into the room where it will be used ,
condensation m ay occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
Cleaning the device
Switch off the device an d unplug the power plug.
Do not clean any interior parts yourself, leave this job to a service technician.
Do not use any cleaning agents t hat contain abrasives o r m ay co rrod e plastic.
Ensure t hat no liquid enters the device.
The display surface of the device is sensitive to pressure and scratches. Clean
it only using a soft, slightly moistened cloth.
The surface o f the casing can be cleane d with a dry cloth. If particu larly dirty, use a cloth that
has been moistened in mild domestic deterge nt and then carefully wrung out .
4 A26361-K1317-Z220-1-7619, edition 2
To Next Page
Loading...
Need help?
General