Fujitsu ErgoPro m664 Series User Manual

ErgoPro m664-series PC Specialist's Handbook
Page 3-8 Edition 1 - Release 1 - March 1998
Mode
Selects the mode for the parallel port. Output Only operates in AT† -compatible mode. Bi-
directional operates in bidirectional PS/2-compatible mode. EPP is Extended Parallel Port mode,
a high-speed bidirectional mode. ECP is Enhanced Capabilities Port mode, a high-speed
bidirectional mode.
Output only
Bi-directional (default)
EPP
ECP
Base I/O address
Specifies the I/O port address of the LPT-port.
378 (default)
278
228
Interrupt
Specfies the h/w interrupt of the LPT-port.
IRQ 5
IRQ 7 (default)
DMA channel
Specifies the DMA channel of the LPT-port that is used in ECP mode.
DMA 1
DMA 3 (default)
Floppy disk controller
Configures the floppy disk controller.
Disabled
Enabled (default)
IDE controller
Configures the IDE controller.
Disabled
Primary
Secondary
Both (default)
Audio
Enables or disables the onboard audio subsystem.
Note: ErgoPro m664-series system board is not equipped with on-board audio
Disabled
Enabled (default)
Legacy USB Support
Enables support for legacy universal serial bus devices.
Disabled
Enabled

Fujitsu ErgoPro m664 Series Specifications

General

Brand	Fujitsu
Model	ErgoPro m664 Series
Category	Desktop
Language	English