Connecting external d evices
Connecting a monitor
Only attach the m onitor to your device w hen switched off.
► F ollow the instructions conta ined in the monitor manual to prepare the monitor
for operation (e.g. connecting cables).
Monitor
► C onnect the data cable of the monitor into the required monitor port of y our device.
You may only then connect the mains cable of the monitor to the monitor socket
of the device if the rated current of the monitor (e.g. 1,2 A - see documentation
for the monitor) is less than the maximum permitted power output of the monitor
socket of the device (e.g. 1,5 A - see type plate on the PC).
► Depending on the configuration level of your device, plug the monitor p ower cable into
a grounded mains ou tlet or into the monitor socket on the device.
Connecting the mouse
You can connect a USB mouse or a PS/2 mouse to your device.
Mouse,Connecting,
Connecting a USB mouse
► C onnect the US
B mouse to one of the USB ports on the de vice.
USBport,USB port
Connecting a PS/2 mouse
The PS/2 mouse is only detected by the device if you connect the mouse w h en
the device is s witched off and then switch the device o n again.
► C onnect th
e PS/2 m ouse to the PS/2 mouse port of the device.
PS/2mouse,Con necting,PS/2mouse,
► Sw itch your device on again.
22 Fujitsu
To Next Page
Loading...
Need help?
General