Problem solutions and tips
The device cannot be switched off with the On/Off switch.
Cause
Troubleshooting
System crash ► Press the On/Off switch for at least
4 seconds, until the device switches off.
Attention: Warning, this could lead to a loss of
data!
The Operating System is not shut-down properly
in the process. Error messages are therefore
possible the next time the system is booted.
Monitor remains blank
Cause
Remedy
Monitor is switched off ► Sw itch your monitor o n.
Power saving h as been activated (screen is
blank)
► Press any key on the keyboard.
or
► Deactivate the s c reen saver. If
necessary, enter the appropriate
password.
Brightness control is set to dark ► Ad just the brightness control. For detailed
information, please refer to the operat ing
manual supplied with your monitor.
Power cable not connected
► Sw itch off the monitor and the device.
► C heck that the monitor power cable is
properly connected to the monitor and to
a grounded mains outlet or to the monitor
socket of the device.
► C heck that the device power cable is
properly plugged into the device and a
grounded mains outlet.
► Sw itch on the m onitor and the device.
Monitor cable no t connecte d
► Sw itch of
f the monitor and the device.
► C heck that the monitor cable is p roperly
connected to the device and monitor.
► Sw itch o
n the monitor and the device.
Incorrect setting for the monitor
► Restar
t the system.
► Press
F
8
while the system is booting.
► Start
the system in Safe M ode .
► Se t up the monitor as described in the
documentation for your operating system
and monitor.
Fujitsu 35
To Next Page
Loading...
Need help?
General