Fujitsu ETERNUS AF250 S2 - Figure 89 Connection Example Without a Dedicated Remote Support Port; Figure 90 Connection Example When the IP Address of the Slave CM Is Set

■
Connection Configurations
MNT ports are used for connecting a LAN for operation management.
Figure 89 Connection Example without a Dedicated Remote Support Port
Remote support
center
RMT ports are not used.
LAN switch
NTP server
Authentication
server
Syslog server
ETERNUS AF
Controller enclosure
RMT MNT
CM#0
RMT
CM#1
IP address A
MNT
Administration
terminal
SNMP
manager
E-mail server
LAN for operation management
The following figure provides connection examples for when setting the IP address of the Slave CM.
Figure 90 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote Support
Port Is Not Used)
Remote support
center
RMT ports are not used.
The IP addr
esses of the Master CM
and the Slave CM are set.
LAN switch
SNMP
manager
NTP server
E-mail server
Authentication
server
Syslog server
LAN for operation management
ETERNUS AF
Controller enclosure
RMT MNT
CM#0
RMT
CM#1
Administration
terminal
IP address BIP address A
MNT
2. Connection Configuration
LAN Connection
136
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1822-09ENZ0