Fujitsu ETERNUS AF250 S2 - Optional Product Installation Conditions; Host Interfaces

Optional Product Installation Conditions
This section provides the types and number of optional products and explains policies for optional product esti-
mations.
Installation conditions for the following optional products are described in this section.
•
Host interfaces
•
Drive enclosures
•
Drives
To install the following optional products in the ETERNUS AF250, a specific firmware version may be required
for the ETERNUS AF.
For details, refer to the "Firmware Release Information" section in "Overview" or refer to "Product List".
•
Drive enclosures
•
Host interfaces (FC)
Host Interfaces
This section explains the installation conditions for host interfaces.
■
Types of Host Interfaces
A host interface is an option that is two per set.
The following types of host interfaces are available:
● ETERNUS AF250 S2
•
FC 32Gbit/s
•
FC 16Gbit/s
•
iSCSI 10Gbit/s (10GBASE-SR (*1)/10GBASE-CR)
•
iSCSI 10Gbit/s (10GBASE-T)
*1: The SFP+ modules are not installed. The SFP+ modules are required to connect the FC cables.
● ETERNUS AF250
•
FC 16Gbit/s
•
iSCSI 10Gbit/s (10GBASE-SR)
•
iSCSI 10Gbit/s (10GBASE-CR)
•
iSCSI 10Gbit/s (10GBASE-T)
● FC
Fibre Channel (FC) enables high speed data transfer over long distances by using optical fibers and coaxial ca-
bles. FC is used for database servers where enhanced scalability and high performance are required.
3. Hardware Configurations
Optional Product Installation Conditions
154
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1822-09ENZ0