Fujitsu Eternus DX80 S2 - Error Messages; A.2.2 Error Messages

Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
113
A.2.2 Error Messages
This section describes the messages that are sent when the severity is Error for each type of event.
■ Error message list
● When the event type is "P"
The following messages are sent when components fail or degrade or when a temperature error is
detected.
Event type
code
SNMP Trap Upper: Message
Remarks
Trap
No.
TrapItemID
Trap
Sensor
Info
Lower: Description
P 01
SSMM 00 2 0100 MM 00
-
Controller Module# m ( zz ) Fault < pppppppppppp
ssssssssss rrrrr
>
These messages are
notified when "Parts
Error" is enabled for
Error Severity Level in
the event notification
setting.
They are not notified
during maintenance
operations.
CM is disconnected.
SS : Component subtype
MM : CM module ID (10 – 11)
m : CM number (0 – 1)
zz : Model name (DX80S2 or DX90S2)
pp... : Component number
ss... : Serial number
rr... : Version
P 02
SSMM 0 p 2 0200 MM 0p
-
Controller Module# m ( zz ) DMA PORT# p Fault
<
pppppppppppp ssssssssss rrrrr >
CM DMA port is disconnected.
SS : Component subtype
MM : CM module ID (10 – 11)
m : CM number (0 – 1)
zz : Model name (DX80S2 or DX90S2)
p : Port number (0 – 1)
pp... : Component number
ss... : Serial number
rr... : Version
P 03
SSMM 0 v 2 0300 MM 0v
-
Controller Module# m ( zz ) BIOS# v Fault
<
pppppppppppp ssssssssss rrrrr >
CM BIOS is disconnected.
SS : Component subtype
MM : CM module ID (10 – 11)
m : CM number (0 – 1)
zz : Model name (DX80S2 or DX90S2)
v : Device number (0 – 1)
pp... : Component number
ss... : Serial number
rr... : Version
P 04
SSMM 00 2 0400 MM 00
-
Controller Module# m ( zz ) RTC Fault
<
pppppppppppp ssssssssss rrrrr >
CM RTC is disconnected.
SS : Component subtype
MM : CM module ID (10 – 11)
m : CM number (0 – 1)
zz : Model name (DX80S2 or DX90S2)
pp... : Component number
ss... : Serial number
rr... : Version