Fujitsu Eternus DX80 S2 - Installable Host Interfaces; Host Interface Handling Instructions; Figure 5.4 Installation Diagram for Host Interfaces (Dual-Controller Type)

Chapter 5 Maintaining Optional Products
5.3 Installing Host Interfaces
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
86
■ For a dual-controller type
Figure 5.4 Installation diagram for host interfaces (dual-controller type)
5.3.2 Installable Host Interfaces
For installable host interfaces, refer to "Product List".
5.3.3 Host Interface Handling Instructions
■ About condensation
■ About static electricity
Expansion Expansion
Host interface (CA#1) Host interface (CA#1)
Controller 0 (CM#0)
Controller 1 (CM#1)
CAUTION
Do
• When moving a host interface from a cold place, such as an un-
conditioned store house in winter, to a warmer place such as an air-
conditioned room, the severe temperature change may result in
condensation forming.
To avoid this, allow the packed host interface sufficient time in the warmer
place (one hour for each 15°C of temperature difference) to adapt to the
new temperature.
CAUTION
Do
• When handling host interfaces, make sure to wear a wrist strap or touch a
metal part to discharge the human body's natural static electricity. Failure
to discharge static electricity may cause device failure.
• Leave the host interface in its package until ready to install it.