Fujitsu Eternus DX80 S2 - Drive Handling Instructions

Chapter 5 Maintaining Optional Products
5.1 Installing Drives
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
66
5.1.3 Drive Handling Instructions
■ About condensation
■ About static electricity
CAUTION
Do
• When moving a drive from a cold place, such as an un-conditioned store house
in winter, to a warmer place such as an air-conditioned room, the severe
temperature change may result in condensation forming.
To avoid this, allow the packed drive sufficient time in the warmer place (one
hour for each 15°C of temperature difference) to adapt to the new
temperature.
CAUTION
Do Not
• Do not touch the surface of the board of the drives.
Do
• When handling drives, make sure to wear a wrist strap or touch a metal part to
discharge the human body's natural static electricity. Failure to discharge
static electricity may cause device failure.
• Leave the drive in its package until ready to install it.