Fujitsu Eternus DX80 S2 - Syslog; A.1.2 Syslog

Appendix A Event Notification Message List
A.1 Message Format
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
105
A.1.2 Syslog
The following formats are available for notification of syslog: "RFC3164" and "RFC5424". The notification
format is specified in ETERNUS Web GUI or ETERNUS CLI.
This section describes examples of syslogs and the details of formats that are output.
■ Output example of a syslog
The number under each underline indicates an item in the table below. A description is provided for each
item.
• "RFC3164" format
• "RFC5424" format
■ Description of each syslog item
<14>Jan 26 11:26:08 10.21.138.81 Storage: 00, 4, I 01030020 5 volume(s) deleted
[No=38 Name=VOL40#0] [No=39 Name=VOL40#1] [No=40 Name=VOL40#2]
[No=41 Name=VOL40#3] [No=42 Name=VOL40#4]
12 3 4567 8
8
8
<14>1 2011-01-26T11:26:08+09:00 10.21.138.81 Storage 00 4 - I 01030020
5 volume(s) deleted [No=38 Name=VOL40#0] [No=39 Name=VOL40#1]
[No=40 Name=VOL40#2] [No=41 Name=VOL40#3] [No=42 Name=VOL40#4]
8
8
12 34567
No. Item Description
1 Priority Priority of the message is output in the following format:
<
Priority >
Priority value indicates the facility and severity of the message. The Priority value is
calculated by "Facility value × 8 + Severity value".
Facility value for messages is always "1".
Severity values for messages are one of the following values:
3: Error
4: Warning
6: Informational
For the "RFC3164" format, the HEADER part follows the PRI part.
For the "RFC5424" format, "1" and then a blank follow the PRI part.