Fujitsu Eternus DX80 S2 - Long Wave SFP+ Modules (16 Gbit;S) Installation Procedure

Chapter 5 Maintaining Optional Products
5.4 Installing Long Wave SFP+ Modules (16Gbit/s)
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
89
5.4.4 Long Wave SFP+ Modules (16Gbit/s) Installation Procedure
This section describes how to replace a Short wave SFP+ module (16Gbit/s) in the host interface (FC 16Gbit/s)
with a Long wave SFP+ module (16Gbit/s).
Procedure
1 Check that all components of the ETERNUS DX Disk storage system are in normal status,
using the [Storage System Status] screen of ETERNUS Web GUI.
2 Check the port location of the Short wave SFP+ module (16Gbit/s) that is to be replaced by
using the Internal Parts information in the [Channel Adapter Detail] screen.
Note that a Short wave SFP+ module (16Gbit/s) is displayed as "16G SFP+(MMF)" in the "SFP Type" field.
3 Turn off the ETERNUS DX Disk storage system.
Refer to "2.1.4 Powering Off" (page 38) for details on how to turn off the ETERNUS DX Disk storage
system.
4 Wear a wrist strap or touch a metal part to discharge the human body's natural static
electricity.
5 Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module
(16Gbit/s) that is to be replaced.
Push the tab on the FC cable connector and pull out the cable.
CAUTION
Do
• If SFP+ modules are installed in a way other as described here, damage and/or
device failure or electrical shock may occur.
Make sure to record the connecting port for the disconnected FC cable.