Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
152
06 F2 89 Rebuild has not started. This sense code is notified when
"Rebuild/Copyback w/o redundant" is
enabled for Error Severity Level in the
event notification setting.
This is not notified during maintenance
operations.
06 F2 89 Redundant copy has not started. This sense code is notified when
"Redundant" is enabled for Error Severity
Level in the event notification setting.
This is not notified during maintenance
operations.
06 F2 8A Rebuild is halted. This sense code is notified when
"Rebuild/Copyback w/o redundant" is
enabled for Error Severity Level in the
event notification setting.
This is not notified during maintenance
operations.
06 F2 8A Redundant copy is halted. This sense code is notified when
"Redundant" is enabled for Error Severity
Level in the event notification setting.
This is not notified during maintenance
operations.
06 F2 8B Rebuild is halted. This sense code is notified when
"Rebuild/Copyback w/o redundant" is
enabled for Error Severity Level in the
event notification setting.
This is not notified during maintenance
operations.
06 F2 8C Copyback is halted.
06 F2 8D Copyback is halted because an error is found in the copy
source drive.
06 F2 8D Redundant copy is halted because an error is found in the
copy source drive.
This sense code is notified when
"Redundant" is enabled for Error Severity
Level in the event notification setting.
This is not notified during maintenance
operations.
06 FB 01 CM error is detected. These messages are notified when
"Parts Warning" is enabled for Warning
Level in the event notification setting.
They are not notified during
maintenance operations.
06 FB 02 CM DMA port error is detected.
06 FB 03 CM BIOS error is detected.
06 FB 04 CM RTC error is detected.
06 FB 05 CM NVRAM error is detected.
06 FB 06 CM EXP error is detected.
06 FB 08 CM DI port error is detected.
06 FB 09 CM EXP IN port error is detected.
06 FB 0A CM EXP OUT port error is detected.
06 FB 0B Many correctable errors occurred in the CM memory.
06 FB 0C CM BUD error is detected.
06 FB 0D CM FAN error is detected.
06 FB 0E CM NAND Controller error is detected.
06 FB 0F CM SCU error is detected.
06 FB 10 CA error is detected.
06 FB 11 CA port error is detected.
06 FB 21 CM FPGA error is detected.
06 FB 22 CM LAN port error is detected.
Sense code
Description Remarks
SK ASC ASCQ
To Next Page
Loading...
