Chapter 4 Connecting Cables
4.3 Drive Enclosure Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
76
The following figure shows an example of destination label attachments on the QSFP cables that
connect the controller enclosure to drive enclosure 1 and that connect drive enclosure 1 to drive
enclosure 2.
2 Connect the controller enclosure to the drive enclosure with the QSFP cable.
2-1 Connect the DI (OUT) port of Controller 0 (CM#0) in the controller enclosure to the DI (IN) port of I/O
module 0 (IOM6#0) in drive enclosure 1 with the QSFP cable.
(1) Connect the plug to be connected to DI (OUT) port, to the DI (OUT) port of the Controller 0
(CM#0).
Controller
enclosure
Drive
enclosure 1
Drive
enclosure 2
To Next Page
Loading...
