Working with the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the m ains adapter cable to the DC
jack (DC IN) of the Port Replicator (1).
► Connect the power cable to the
mains adapter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the s etting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/OFF
switch on the port
replicator to sw
itch the notebook on.
The power-on indicator of the Port
Replicator lights up.
Switching
off notebook via Port Replicator
► C lose all applications and shut dow n your operating system (please refer
to the manual f o r the operating system).
If the noteboo k cannot be shut down prop erly, press th e ON/OFF button
on the Port Replicator for approx. four seconds. The note book will switch
off. Any unsaved d ata may however be lost.
46 Fujitsu Technology S olutions
To Next Page
Loading...
