Working with the notebook
Wireless LAN/Bluetooth wireless components
The installation of wireless components not approved by Fujitsu will
invalidate the certifications issued for this device.
This computer uses an Intel® W ireless AC 9560 module. Acco rding to Intel®, this
module supports 256-bit AES-GC MP encryption. Full support depends on the general
industrial availability of operating syste ms with WPA3 Enterprise and associated support.
Switching the wireless components on and off
► Press the key to change the wireless components mode.
WirelessLANWirelessLANBluetoothBluetooth
The w ireless indicator will illuminate when one or more wireless components are switched on.
When you turn off the radio com ponents, the wireless LAN antenna
and the Bluetooth module a re turned off.
You can tu rn the installed radio components on and off individually
using the radio components settings.
Observe the additional safety instructions for devices with wireless components
in the section "
Important notes", Page 13.
Details on using a wireless LAN can be found in the online help system
included in the wireless LAN software.
For more information on using Bluetooth, see the information
accompanying the Bluetooth device.
Configuring WLAN access
• Requireme
nt: A WLAN is available and you have th e necessary access data on hand.
Informat
iononconfiguring WLAN access can be found in the
document
ation for your operating system.
Furthe
r information on WLAN and Bluetooth
For further information about WLAN or Bluetooth, please refer to the
appendix of this Operating Ma nual.
For W LAN specifications, see chapter "
WLAN specifications", Page 70.
Fujitsu 39
To Next Page
Loading...
