Working w ith the notebook
Setting up the dock
Choose a suitable lo cation for the dock before setting it up. In doing
so, please follow these instructions:
• Never place the dock on a soft surface (e.g . carpeting, upholstered furniture, bed). This
can block the air vents of the notebook and cause overheating and damage.
• Place the dock on a stable, flat, non-slippery surface. Please note that the rubber
feet of th e dock m ay mark certain types of delicate surfaces.
• Never place the dock or the AC adapter on a heat-sensitive surface.
• Do not expose the dock to extrem e environmental conditions.
Protect the dock against dust, humidity and heat .
Connecting the AC adapter to the port replicator
3
1
2
► Connect up the power cable (1) to the
network adapter provided for the device,
see chapter "
Technical data", Page 69 .
► Plug the AC cable into the power outlet (2).
► Connect the AC adapter cable to the DC
jack (DC IN) of the port replicator (3).
When the notebook is connected to a port replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the m onitor
which was last used for output is saved as a setting. This profile will be loaded as
soon as the notebook is conn ected to a port replicator of the same type.
42 Fujitsu
To Next Page
Loading...
