Fujitsu M10 Product Notes

Table 3-6
Problems resolved in XCP 2240 (continued)
SPARC M10-
RTINo. 1 4 4S Description Worka rou nd
RTIF2-
141106-001
xAny of the following errors related to
abnormal temperature may be
erroneously registered.
- Temperature out of range error
- High temperature at SW
In these error logs, the first two bytes of
the second field in [Code:] has the value
of "0013".
There is no effective workaround.
Ignore this message because there
is no
impact on system operation.
RTIF2-
141110-001
xldm(1M) may not display correct CPU
utilization and may not work the
dynamic resource management (DRM)
on large domain system where 150
domains or more exist.
There is no effective workaround.
RTIF2-
141113-001
x x x Security fixes. (CVE-2014-3566)
For detail, see the Oracle website relating
to the following:
Critical Patch Updates
Update the XCP firmware to XCP 2240 or
later.
RTIF2-
141203-001
xx x In some rare cases, "CPU Internal Serious
error" might occur.
There is no effective workaround.
RTIF2-
141208-002
x x x After a "CPU fatal error" occurs, the time
required for a physical partition (PPAR)
restart may be 6 to 30 minutes longer
than usual. The required restart time
varies depending on the number of
mounted PCIe cards.
If many PCIe cards are mounted, the
following error may be mistakenly
detected.
- In
the case of a SPARC M10-4S system
consisting of 2BB or more
"SRAM data error"
- In the case of a SPARC M10-1/M10-4
systemv>"Timeout of Reset Watch.
PPARID 0"
There is no effective workaround.
[How to restore]
- If "SRAM data error" has been detected
Replace the component at the
suspected location indicated
by the
error log. After that, update the XCP
firmware to XCP 2240 or later.
- If "Timeout of Reset Watch. PPARID 0"
has been detected
Update the XCP firmware to XCP 2240
or later.
RTIF2-140711-001 additional information
This problem (RTIF2-140711-001) has been resolved for XCP 2240 and later versions.
However, the Oracle Solaris time may deviate if a physical partition is started up
immediately after updating the firmware from XCP 2232 or earlier to XCP 2240 or
later. To synchronize the time, see "Notes on the logical
domain time."
Chapter 3 Information on Software 89

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English